Everybody's doing it...re-amping is the not-so-secret weapon in a bunch of studio's bags of tricks. Of course, not only can you output your recorded guitar to a favourite amp (re-amp), but also vocals, bass, percussion...you get the picture.
Take a balanced cable from your computer (or recorder / mixer), connect it to the PRORMP input. It will match impedance and eliminate ground loops on the way to your amp. Now you can re-record with any tone you can dial in. Sweet.
- Play pre-recorded tracks through amps and pedals
- On board level control for fine tuning amp level
- Transformer isolated to eliminate buzz and hum
- Opens the door to creative new tones and textures
The Radial ProRMP is a 100% passive Reamper. This means it does not require any external powering. The magic behind the ProRMP's great tone is a custom wound transformer that at once converts the balanced line level source to a hi-z output for your amp while also acting as an electrical isolator to eliminate troublesome ground loops that can often cause buzz and hum in the sound. Plug and play easy to use, the ProRMP connects from the recorder to your amp and effects units and does all the impedance matching for you. Just adjust the level to suit!
|Audio circuit type:||Passive, transformer isolated|
|Frequency response:||20Hz ~ 20KHz (+0/-1dB)|
|Equivalent input noise:||>-98dbu Noise plus gain|
|Phase deviation:||0.3° @ 100Hz; 5° @ 20Hz|
|Total harmonic distortion:||0.003%|
|Common mode rejection ratio:||100dB @ 60Hz (unbalanced source)|
|Input impedance:||600 Ohms|
|Output impedance:||600Ω, balanced|
|Signal to noise ratio:||81db|
|180° polarity reverse:||Inverts signal polarity|
|Ground lift:||Disconnects pin-1 at XLR output|
|Merge:||Input summing mixer|
|Speaker filter:||-30dB pad and band-pass filter|
|XLR configuration:||AES standard (pin-2 hot)|
|Power:||Passive, no power required|
|Construction:||14 gauge steel chassis and outer shell, baked enamel finish|
|Size:||84 x 127 x 48mm|