DPA

DPA MMP-A

State-of-the-art Preamplifier for Reference Series

Order Code: MMP-A
Enquire
Our Price: $585.00

As a large part of the 4006A omnidirectional condenser microphone, the MMP-A houses all the components to make sure the signal is passed in the best possible condition. An ultra-transparent transformerless preamplifier with active drive for impedance balancing.

Combine with MMC4006 to create a 4006A microphone. Other capsules to consider in the 4000 series include MMC4011 cardioid, MMC4015 wide cardioid, and MMC4017 shotgun. You may also use this preamp to match with the new twin diaphragm 2000 series, at a lower cost, including MMC2006 omni and MMC2011 cardioid capsules.

Photo of DPA MMP-A available from Factory Sound

Other preamplifier models in DPA's Reference Series are: MMP-C compact preamplifier and MMP-B preamplifier with filters.

Output connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Low-cut frequency, -3 dB: 8 Hz
Noise with shorted input, A-weighted: 0.5 µV
Output voltage, RMS: > 5 V
Output voltage, peak: > 16 V
Type of electronic circuit: Active
THD@1VRMS, 1kHz: < 0.2 %
Dynamic range: 138 dB
Switchable attenuator: 0 dB, -20 dB
Output impedance: < 200 ohm
Output balance principle: Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR): > 60 dB
Power supply (for full specifications): 48 V Phantom power (± 4 V)
Current consumption: 2.8 mA
Color: Matte black
Weight: 140 g
Diameter: 19 mm
Length: 147 mm
Cable drive capability: 100 m
Temperature range: -40 °C to 45 °C
Relative Humidity (RH): Up to 90 %